typos fixed thanks to Calvin

1 files changed, 12 insertions, 11 deletions

diff --git a/supcon.tex b/supcon.tex
index 3a5d408..0e13d84 100644
--- a/supcon.tex
+++ b/supcon.tex
@@ -75,7 +75,7 @@ place items in the liquid nitrogen.
 
 
 \section*{Experimental procedure}
-\textbf{Equipment needed}: YBCO disc, tweezers, styrofoam dish, small magnet.
+\textbf{Equipment needed}: YBCO disk, tweezers, thermal insulating container, small magnet.
 
 
 
@@ -84,17 +84,18 @@ place items in the liquid nitrogen.
 \begin{enumerate}
 
 \item Place one of the small magnets (provided) on top of the superconducting
-disc at room temperature. Record the behavior of the magnet.
+disk at room temperature. Record the behavior of the magnet.
 
-\item  Using the tweezers, place the superconducting disk in the styrofoam
-   dish. Attach  the thermocouple leads (see diagram) to a multimeter
+\item  Using the tweezers, place the superconducting disk in the thermal
+	insulating container.
+	Attach  the thermocouple leads (see diagram) to a multimeter
    reading on the mV scale. Slowly pour liquid nitrogen over the disk,
-   filling the dish as much as you can. The nitrogen will boil, and
+   filling the container as much as you can. The nitrogen will boil, and
    then settle down. When the multimeter reads about 6.4 mV, you are
    at liquid nitrogen temperature (77 K).
 
 
-\item After the disc is completely covered by the liquid nitrogen, use the tweezers
+\item After the disk is completely covered by the liquid nitrogen, use the tweezers
 to pick up the provided magnet and attempt to balance it on top of the
 superconductor disk. Record what you observe.
 
@@ -110,7 +111,7 @@ moving the magnet across the superconductor. Do you feel any resistance? If you
    critical temperature. Make sure you record it!
 
 \item Repeat the experiment by starting with the magnet on top of the
-superconductor disc and observe if the magnet starts levitating when the disk's
+superconductor disk and observe if the magnet starts levitating when the disk's
 temperature falls below critical.
 
 \end{enumerate}
@@ -138,10 +139,10 @@ At room temperature, you should be reading a non-zero
 
 \begin{enumerate}
  \item With the voltage, current and thermocouple leads attached,
-    carefully place disk in dish. Pour liquid nitrogen into the
-    dish. Wait until temperature reaches 77 K.
-\item With tweezers,  take disk out of nitrogen and place on a side of the
-   dish. {\bf Start quickly recording the current, voltage and thermocouple readings
+    carefully place the disk in the container. Pour liquid nitrogen into the
+    container. Wait until temperature reaches 77 K.
+\item With tweezers,  take the disk out of nitrogen and place it outside of
+	the container. {\bf Start quickly recording the current, voltage and thermocouple readings
    as the disk warms up.} When superconducting, the disk should have
    V=0 (R=0). At a critical temperature, you will see a voltage
    (resistance) appear.